AWWA Vs. ANSI Flange Standards

Both the and ANSI have thorough standards for flanges, and the two standards are different in several ways.

AWWA standards provide flange properties intended for potable water use only. In contrast, ANSI standards are aimed at industrial flange applications. For example, ratings are applicable only at atmospheric temperature, while ANSI ratings cover flange installations from -20°F to 1500°F.

ANSI covers numbered class flanges from 150 to 2500, and AWWA standards encompass lettered flange classes B, E, F, and the commonly used class D connection. AWWA provides ratings for a much broader range of nominal pipe sizes (3″-144″) than ANSI provides (1/2″-24″).

Finally, ANSI and AWWA flange standards differ in the breadth of applications discussed. ANSI includes information for welded auxiliary connections and tapping, while AWWA does not address those installations. Also, the AWWA standard only encompasses ring, hub type, , and threaded iron flanges while the ANSI standard inlcudes all flange types.

This discussion on AWWA flange standards and ANSI flange standards is based on information from ANSI/AWWA C115/A21.15-99: “American National Standard for Flanged Ductile-Iron Pipe with Ductile-Iron or Gray-Iron Threaded Flanges”, ANSI/AWWA C207-94: “AWWA Standard for Steel Pipe Flanges for Waterworks Service-Sizes 4 In. Through 144 In.”, and -1981: “Pipe Flanges and Flanged Fittings”.

Related products maybe you like
Dimensional tolerances for AWWA pipe flanges
Main uses of stainless steel
Standard Standard for Welded Carbon Steel Tubes
Piping Elbows and Bends
3D BENDS are used are in 10 applications
5D bend in pipe
/A105M

Leave a Reply

Your email address will not be published. Required fields are marked *