Pipe Fittings Inspection

During the manufacturing various Inspection & Testing are carried out on pipe fitting to ensure quality of the product.

Hydrotest for

  • Hydrostatic Test Not required for pipe fittings unless specifically requested by purchaser
  • Code mandate that fittings shall be able to withstand under pressure required by applicable Code.
  • Most purchasers mandate, that a hydro tested pipe shell be used to manufacture fittings.

 

Proof Test
Brust Test Proof Test
Brust Test Proof Test

To qualified the design of the pipe fitting, manufacturer performed a various test including burst test to ensure that design will meet the all the standard & code requirements. In this test, a pipe & fittings are welded and a dummy pipe spool is prepared. This pipe spool is then pressurized to pre-define calculated burst test pressure. If the fittings withstand the test, all the future product manufactured using that design will consider safe to use.

Lap joint stub ends are exempt from the proof test because they are used with flange assembly and design considering applicable pressure- temperature ratings.

Non-Destructive testing

Based on the type of fittings any of the following Non-Destructive testings are performed on finished fittings to ensure the soundness of product.

  • Ultrasonic
  • Radiography (Only for Weld)
  • Magnetic particle test
  • Liquid penetrant test
  • And Positive Material Identification
Destructive Testing

Destructive Testings are performed to check the strength of the body and weld of the product.

  • The proof test is also known as type test or burst test.
  • Tensile test
  • Impact test / Charpy V-Notch Test
  • Hardness test
Metallurgical Tests

Metallurgical Tests are performed on fittings body and weld to confirm standard requirements

  • Micro Analysis or Chemical Analysis of
    • Raw material
    • Product
    • Weld
  • Macro Analysis
    • Weld
Special Tests
  • Special tests are carried out on fittings to confirm its ability to withstand in corrosive environments. These tests are
    • IGC- Intergranular Corrosion Test(SS)
    • Ferrite (SS)
    • HIC- Hydrogen-induced Cracking
    • And SSC- Sulfide Stress Corrosion Cracking
    • Grain size (AS & SS) of material are checked to confirm microstructure
Visual Inspection

Visual Inspection is conducted on fittings to check any surface imperfections. Both fittings body and weld are checked for any visible surface imperfections such as dents, die marks, porosity, undercuts etc. Acceptance as per applicable standard.

Visual Inspection
Visual Inspection

Pipe Fitting Marking

Following shall be marked on Fittings

  • Manufacturer logo
  • material code
  • Material Grade
  • Size, for tee size of branch & run pipe and for reducer size of both end
  • Thickness (Schedule No) for both the ends if they are connected to different thickness pipe
  • Heat No

Compliance – for standard fittings –WP, for Special fittings S58, S8, SPLD etc.

Related products maybe you like
Pipe Material
What is a Gasket
Threadolet Dimensions
Dimensions
Elbow Manufacturing Process
High Temperature Service Pipe
Butt weld fittings

Leave a Reply

Your email address will not be published. Required fields are marked *